For Arctic, border and remote-site operators
Powering drones through an Arctic winter
Remote field sites in Greenland and the Nordic north are where drones are most useful and where their power systems fail first. This page explains why cold is hard for batteries and PEM fuel cells, how a solid oxide fuel cell is designed around it, and which of our cold-weather figures are still targets.
Why cold is the hard problem
Batteries lose usable capacity as the temperature falls, and in the Arctic every litre of fuel and every spare pack is flown in. Each power technology meets the cold differently:
- PEM fuel cells: product water freezes in the cathode at sub-zero temperatures (Pistono and Rice, Molecules, 2020); open-cathode stacks can also dry out the membrane (Yang et al., Applied Energy, 2022).
- Combustion engines: a heavy-fuel ScanEagle flew at −16 to −6 °C with no problems (Insitu, 2007). Not shown to −45 °C.
- Conventional SOFC: we found no cold-weather flight data in public sources.
How a solid oxide fuel cell is designed around the cold
A solid oxide cell operates above 600 °C inside, by design. That changes the question from “will the chemistry still work?” to “can the module keep its heat?”, which is a thermal-engineering problem. A solid oxide stack has no polymer membrane to dry out and no low-temperature cathode in which product water can freeze, the failure modes known for PEM stacks.
The NEOVIUX module is targeted to operate from −45 to +50 °C. The cell is printed as one ceramic monolith, which also removes the glass seals and metal interconnects that oxidise and age at operating temperature. The hybrid module also includes a battery. A solid oxide stack needs time to reach operating temperature, and the start-up target is under 20 minutes.
These are targets. Module-level cold-start and −45 °C operation have not yet been measured, the module is at TRL 3–4, and endurance figures are modelled. The cell results behind the design are published in Nature Energy (2025).
Missions where cold decides the power system
- Arctic science and environmental monitoring: quiet, cold-tolerant coverage of remote sites, where a quiet aircraft also disturbs less of what it observes.
- Border and coastal surveillance on 15–35 kg aircraft: patrols that have to hold year-round, with no combustion-engine noise to give the aircraft away.
- Maritime surveillance: more time on station per flight, and turnarounds measured in a refuel rather than a recharge.
- Remote cargo and resupply: energy that weighs less leaves more of the aircraft’s lift for the load.
Europe’s Arctic agenda
On 20 October 2026 the European Commission adopted a new Arctic strategy that puts security, surveillance and critical infrastructure at its centre, including a maritime security hub that starts with an Arctic cable hub (European Commission). Persistent monitoring of long coastlines and remote infrastructure needs aircraft that keep flying in winter, which is exactly where battery-electric platforms are weakest.
If you operate or specify aircraft for polar or cold-climate work, we would like to hear what your coldest working day looks like. Our SOFC module overview has the full list of targets.
Frequently asked questions
- Why do drone batteries lose range in the cold?
- Battery chemistry slows as temperature falls, so less of the stored energy can be drawn at a useful rate. Published battery-powered UAV datasheets give a lower operating limit; check it against the coldest day at your site and plan the mission with margin.
- Does a fuel cell work better than a battery in the cold?
- It depends on the type. A PEM fuel cell has to manage product water, which can freeze in the cathode. A solid oxide fuel cell runs above 600 °C internally, with no polymer membrane and no low-temperature cathode, so it does not face that failure mode. Its challenge is keeping the module warm.
- Is operation at −45 °C proven for the NEOVIUX module?
- No. −45 to +50 °C is the development target for the module. Cell results are published and peer-reviewed; module-level cold testing is still ahead, and the module is at TRL 3–4.
- How long does a solid oxide fuel cell take to start?
- Longer than an engine or a PEM stack, because it has to reach operating temperature. Our target is under 20 minutes. It is a target, not a measured figure.
- Which fuels work for remote Arctic sites?
- The module is designed for ethanol, methane, propane and LPG: liquid and gas fuels that are easy to handle, and that Europe already produces, stores and moves.
Brief us on your aircraft
Aircraft makers, operators and research teams can request the technical sheet. We review each request and answer it personally.
